Omega DP119-RTD Manual do Utilizador descarregar pdf (Página 21)

3.5 Analog Output Connections

The analog output is a linearized millivolt signal that is equivalent

to the displayed temperature. It comes as a standard feature

with every unit. The resolution of the analog output is no greater

than the resolution of the display.

The analog output is a non-isolated signal.

To access the analog signal, attach copper wire to the 3-pin

female connector that is supplied with the meter. Refer to

Figure 3-9 for wiring instructions. Plug the female connector into

the P2 (male) connector at the rear of the meter.

Figure 2-2 shows the location of the P2 connector on the meter.

Note that this connector shares a common return with the

ÒDisplay Hold" function.

Figure 3-9. Analog Output Connections (P2)

RETURN

Screws

underneath

Output

–

Note

☞

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sem comentários

Omega DP119-RTD Manual do Utilizador Página 21