Omega IP710 Manual do Utilizador

User’s GuideIP710 SERIESI/P ConvertersShop online atomega.com e-mail: [email protected] latest product manuals:omegamanual.info

2.3 Reverse Acting Calibration2.3.1 When calibrated to operate in the reverse acting mode the minimum input signal produces the maximum outputpressure

Page 83. MAINTENANCE AND REPAIRSUnder normal circumstances, no maintenance should be required.3.1 Cleaning3.1.1 If clean, dry air is not used the orif

M-4063/0307Where Do I Find Everything I Need for Process Measurement and Control? OMEGA…Of Course!Shop online at www.omega.comTEMPERATUREMUThermocoupl

Servicing North America:USA: One Omega Drive, P.O. Box 4047ISO 9001 Certified Stamford CT 06907-0047TEL: (203) 359-1660 FAX: (203) 359-7700e-mail: inf

WARRANTY/DISCLAIMEROMEGA ENGINEERING, INC. warrants this unit to be free of defects in materials and workmanship for aperiod of 13 months from date of

Page 11.0025.42.9474.7123.6993.72.1855.4.1253.17.50012.71.8045.71.3033.01.5038.1Mounting Holes#10–32 UNF–2BX 3/8 Deep2 Places22 GA. wire l

DANGER, WARNING, CAUTION and NOTE statementsRefers to conditions or hazards which could result in serious personal injury or death.Refers to condition

1. DESCRIPTION and INSTALLATION1.1 Description1.1.1 The Omega IP710 converts a current input signal to a linearly proportional pneumatic output pressu

Figure 3 - DIN 43650 Connector DIN Rail mounting kit IP610-DM1.4 Pneumatic Connections1.4.1 Clean all pipe lines to remove dirt and scale before insta

1.6 Factory Mutual Research Corporation (FM)and Canadian Standards association (CSA)Factory Mutual and Canadian Standards Association I.S. Installatio

2. OPERATION2.1 Calibration2.1.1 All units are shipped from the factory calibrated, direct acting.2.1.2 If the user requires a different mode of opera